paper, we show that it is interesting to use SimGrid to simulate the behaviors
of asynchronous iterative algorithms. For that, we compare the behaviour of a
synchronous GMRES algorithm with an asynchronous multisplitting one with
-simulations in which we choose some parameters. Both codes are real MPI
-codes. Simulations allow us to see when the multisplitting algorithm can be more
+simulations which let us easily choose some parameters. Both codes are real MPI
+codes ans simulations allow us to see when the asynchronous multisplitting algorithm can be more
efficient than the GMRES one to solve a 3D Poisson problem.
all clusters are interconnected by a virtual unidirectional ring network (see
Figure~\ref{fig:4.1}). During the resolution, a Boolean token circulates around
the virtual ring from a master processor to another until the global convergence
-is achieved. So starting from the cluster with rank 1, each master processor $i$
+is achieved. So starting from the cluster with rank 1, each master processor $\ell$
sets the token to \textit{True} if the local convergence is achieved or to
-\textit{False} otherwise, and sends it to master processor $i+1$. Finally, the
+\textit{False} otherwise, and sends it to master processor $\ell+1$. Finally, the
global convergence is detected when the master of cluster 1 receives from the
master of cluster $L$ a token set to \textit{True}. In this case, the master of
cluster 1 broadcasts a stop message to masters of other clusters. In this work,
\begin{table}[!t]
\centering
- \caption{2 clusters, each with 50 nodes}
+ \caption{Relative gain of the multisplitting algorithm compared to GMRES for
+ different configurations with 2 clusters, each one composed of 50 nodes.}
\label{tab.cluster.2x50}
\begin{mytable}{5}
After analyzing the outputs, generally, for the two clusters including one hundred hosts configuration (Tables~\ref{tab.cluster.2x50}), some combinations of parameters affecting
the results have given a relative gain more than 2.5, showing the effectiveness of the
-asynchronous performance compared to the synchronous mode.
+asynchronous multisplitting compared to GMRES with two distant clusters.
With these settings, Table~\ref{tab.cluster.2x50} shows
-that after a deterioration of inter cluster network with a bandwidth of \np[Mbit/s]{5} and a latency in order of one hundredth of millisecond and a processor power
+that after setting the bandwidth of the inter cluster network to \np[Mbit/s]{5} and a latency in order of one hundredth of millisecond and a processor power
of one GFlops, an efficiency of about \np[\%]{40} is
obtained in asynchronous mode for a matrix size of 62 elements. It is noticed that the result remains
stable even we vary the residual error precision from \np{E-5} to \np{E-9}. By
%\LZK{Ma question est: le bandwidth et latency sont ceux inter-clusters ou pour les deux inter et intra cluster??}
%\CER{Définitivement, les paramètres réseaux variables ici se rapportent au réseau INTER cluster.}
\section{Conclusion}
-The experimental results on executing a parallel iterative algorithm in
-asynchronous mode on an environment simulating a large scale of virtual
-computers organized with interconnected clusters have been presented.
-Our work has demonstrated that using such a simulation tool allow us to
+The simulation of the execution of parallel asynchronous iterative algorithms on large scale clusters has been presented.
+In this work, we show that SIMGRID is an efficient simulation tool that allows us to
reach the following three objectives:
\begin{enumerate}
executing the algorithm in asynchronous mode.
\end{enumerate}
Our results have shown that in certain conditions, asynchronous mode is
-speeder up to \np[\%]{40} than executing the algorithm in synchronous mode
+speeder up to \np[\%]{40} comparing to the synchronous GMRES method
which is not negligible for solving complex practical problems with more
and more increasing size.
- Several studies have already addressed the performance execution time of
+Several studies have already addressed the performance execution time of
this class of algorithm. The work presented in this paper has
demonstrated an original solution to optimize the use of a simulation
tool to run efficiently an iterative parallel algorithm in asynchronous
mode in a grid architecture.
-\LZK{Perspectives???}
+In future works, we plan to extend our experimentations to larger scale platforms by increasing the number of computing cores and the number of clusters.
+We will also have to increase the size of the input problem which will require the use of a more powerful simulation platform. At last, we expect to compare our simulation results to real execution results on real architectures in order to experimentally validate our study.
\section*{Acknowledgment}
This work is partially funded by the Labex ACTION program (contract ANR-11-LABX-01-01).
-\todo[inline]{The authors would like to thank\dots{}}
+%\todo[inline]{The authors would like to thank\dots{}}
% trigger a \newpage just before the given reference
% number - used to balance the columns on the last page
