\RC{Ordre des autheurs pas définitif.}
\LZK{Adresse de Lilia: Inria Bordeaux Sud-Ouest, 200 Avenue de la Vieille Tour, 33405 Talence Cedex, France \\ Email: lilia.ziane@inria.fr}
\begin{abstract}
-The abstract goes here.
+ABSTRACT
+
+In recent years, the scalability of large-scale implementation in a
+distributed environment of algorithms becoming more and more complex has
+always been hampered by the limits of physical computing resources
+capacity. One solution is to run the program in a virtual environment
+simulating a real interconnected computers architecture. The results are
+convincing and useful solutions are obtained with far fewer resources
+than in a real platform. However, challenges remain for the convergence
+and efficiency of a class of algorithms that concern us here, namely
+numerical parallel iterative algorithms executed in asynchronous mode,
+especially in a large scale level. Actually, such algorithm requires a
+balance and a compromise between computation and communication time
+during the execution. Two important factors determine the success of the
+experimentation: the convergence of the iterative algorithm on a large
+scale and the execution time reduction in asynchronous mode. Once again,
+from the current work, a simulated environment like Simgrid provides
+accurate results which are difficult or even impossible to obtain in a
+physical platform by exploiting the flexibility of the simulator on the
+computing units clusters and the network structure design. Our
+experimental outputs showed a saving of up to 40 \% for the algorithm
+execution time in asynchronous mode compared to the synchronous one with
+a residual precision up to E-11. Such successful results open
+perspectives on experimentations for running the algorithm on a
+simulated large scale growing environment and with larger problem size.
+
+Keywords : Algorithm distributed iterative asynchronous simulation
+simgrid
+
\end{abstract}
\section{Introduction}
challenge an efficiency by \np[\%]{78} with a matrix size of 100 points, it was
necessary to degrade the inter cluster network bandwidth from 5 to 2 Mbit/s.
-A last attempt was made for a configuration of three clusters but more power
+A last attempt was made for a configuration of three clusters but more powerful
with 200 nodes in total. The convergence with a speedup of \np[\%]{90} was obtained
with a bandwidth of \np[Mbits/s]{1} as shown in Table~\ref{tab.cluster.3x67}.
\section{Conclusion}
+CONCLUSION
+
+The experimental results on executing a parallel iterative algorithm in
+asynchronous mode on an environment simulating a large scale of virtual
+computers organized with interconnected clusters have been presented.
+Our work has demonstrated that using such a simulation tool allow us to
+reach the following three objectives:
+
+\newcounter{numberedCntD}
+\begin{enumerate}
+\item To have a flexible configurable execution platform resolving the
+hard exercise to access to very limited but so solicited physical
+resources;
+\item to ensure the algorithm convergence with a raisonnable time and
+iteration number ;
+\item and finally and more importantly, to find the correct combination
+of the cluster and network specifications permitting to save time in
+executing the algorithm in asynchronous mode.
+\setcounter{numberedCntD}{\theenumi}
+\end{enumerate}
+Our results have shown that in certain conditions, asynchronous mode is
+speeder up to 40 \% than executing the algorithm in synchronous mode
+which is not negligible for solving complex practical problems with more
+and more increasing size.
+
+ Several studies have already addressed the performance execution time of
+this class of algorithm. The work presented in this paper has
+demonstrated an original solution to optimize the use of a simulation
+tool to run efficiently an iterative parallel algorithm in asynchronous
+mode in a grid architecture.
\section*{Acknowledgment}
